WEB Configuration of DS-3E2300P Series Ethernet SwitchEW
[
选取日期
]
5
6) Open the telnet function.
1.1.3 Setting the HTTP Port
Generally, the HTTP port is port 80 by default, and users can access a switch by entering
the IP address directly; however, switches also support users to change the service port
and after the service port is changed you have to use the IP address and the changed port
to access switches. For example, if you set the IP address and the service port to
192.168.1.3 and 1234 respectively, the HTTP access address should be changed to http://
192.168.1.3:1234. You’d better not use other common protocols’ ports (such as ftp-20,
telnet-23, dns-53, snmp-161) so that access collision should not happen. Because the
ports used by a lot of protocols are hard to remember, you’d better use port IDs following
port 1024.
Command
Purpose
ip http port { portNumber }
Setting the HTTP Port
1.1.4 Enabling the HTTP service
Switches support to control the HTTP access. Only when the HTTP service is enabled can
HTTP exchange happen between switch and PC and, when the HTTP service is closed,
HTTP exchange stops.
Command
Purpose
ip http server
Enabling the HTTP service
1.1.5 Setting the HTTP Access Mode
You can access a switch through two access modes: HTTP access and HTTPS access, and
you can use the following command to set the access mode to HTTP.
Command
Purpose
ip http http-access enable
Setting the HTTP Access Mode
1.1.6 Setting the Maximum Number of VLAN Entries
Displayed on a Web Page
A switch supports at most 4094 VLANs and in most cases Web only displays parts of
VLANs, that is, those VLANs users want to see. You can use the following command to set
the maximum number of VLANs. The default maximum number of VLANs is 100.
All manuals and user guides at all-guides.com