High End Systems intellaspot XT-1, User Manual

Page: 85 / 98

CHAPTER 5
General Maintenance and Troubleshooting
intellaspot TM XT-1 User Manual 71
Replacing the Animation Wheel
Use these steps to replace the animation wheel if it is broken, or to change to a custom wheel.
Note: You can find drawings and specifications for a custom animation wheel on the
intellaspot support page at www.highend.com/support/automated_luminaires.
1. Loosen the four captive screws on each side and
remove the head covers.
1. Rotate and lock the head perpendicular to the
electronic housing to access the color mix
animation module.
2. Loosen harness connections to the color mix
animation module by freeing the grommets from
their slots.
3. Use a flathead screwdriver to loosen two captive
screws holding the module to the head and slide
the module out of the fixture.
4. Lay the module down with the Animation wheel
side up.
5. Loosen the two cap screws on the wheel hub.
6. Slide the wheel and lift off the wheel shaft.
7. Place the new wheel through the keyhole slot and
slide into place.
8. Retighten the cap screws on the
hub.
9. Replace the module
10. Replace the harness grommets.
11. Replace the head covers.
WARNING! To avoid electrical shock, disconnect power before servicing.
Equipment surfaces may reach temperatures up to 130° C (266° F).
Allow the fixture to cool before handling.