High End Systems intellaspot XT-1, User Manual

Page: 75 / 98

CHAPTER 5
General Maintenance and Troubleshooting
intellaspot TM XT-1 User Manual 61
Replacing Display Batteries
Four AA cell rechargeable batteries power the intellaspot XT-1 LCD display. They are located in a
bracket on the back of the display panel. Replace with Sanyo Eneloop, Rayovac Platinum, or
comparable precharged rechargeable AA cell 1.2V NiMH batteries.
The battery charger activates power is applied to the fixture. It charges the battery for one hour.
After that, the charger will be disabled to avoid overcharging the battery.
Replacing the Lamp
Please review and follow these warnings and cautions before replacing the lamp.
CAUTION:Insert the batteries as shown in the holder. Reversing the
direction can blow the fuse, damage the battery, or prevent the battery
from operating.
Anything loose in the road case that could inadvertently actuate the MENU
and ENTER keys can drain the battery.
Do not mix old and new batteries or batteries of differing types.
WARNING: To avoid electrical shock, disconnect power before re-
lamping or servicing.
An operating, unshielded lamp emits ultraviolet and visible
(UV-vis) radiation which could damage eyes and skin. Whenever
working on or near an exposed lamp, wear protective eye gear. Never
look directly at the lamp while the lamp is on.
Hot lamp may be an explosion hazard. Do not open for five minutes
after switching off.
Equipment surfaces may reach temperatures up to 130° C (266° F).
Allow the fixture to cool before handling.
CAUTION: This equipment is designed for use with a 850W HID lamp
only. Use of any other type lamp may be hazardous and may void the
warranty.