COMPUSHIFT II Manual – COMPUSHIFT II Manual
Additional Guides & Information
–
92
Attach the adjustable arm by rotating the throttle position sensor so that its pin can be inserted into the adjustable
arm. The picture above shows the arm in its fully installed position.
Do not lubricate the linkage. The AccuLink system is designed to work WITHOUT lubrication. Most lubricants will
attract dirt, shortening the life of the system.
7.5.13 Checking the Adjustable Arm and Sensor
Check the adjustable arm with the throttle fully closed. There should be tension on the arm and no free play.
Correct any free play by shortening the arm slightly.
Hold the carburetor linkage in the fully open position. Verify that the throttle position sensor has some remaining
stroke / rotation by pressing on the sensor arm as shown above. The sensor should have some additional travel /
rotation. If the sensor is fully extended, lengthen the arm slightly to correct.
THE THROTTLE POSITION SENSOR SHOULD NOT REACH THE END OF ITS ROTATION OR STROKE IN EITHER
DIRECTION. IT SHOULD BE SLIGHTLY OFF THE STOP AT EACH END OF ITS TRAVEL. FAILURE TO DO THIS COULD
RESULT IN POOR OPERATION.
