COMPUSHIFT II Manual – COMPUSHIFT II Manual
Preparing for Your Installation
–
13
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Where to mount your COMPUSHIFT II Controller.
Where to install the firewall grommets for your wiring harnesses.
How to route the wiring harnesses to the engine and transmission.
1.4 Other Considerations
COMPUSHIFT II can provide an electronic signal to
operate an electronic speedometer
.
COMPUSHIFT II also provides a signal that duplicates the speed sensor (TOSS) in your transmission. This can
run an original in-dash speedometer
, and eliminates the need for dual speed sensors.
Refer to the
COMPUSHIFT II Quick Install Guide
, also included in the packaging, to get an overview
of all the components.
1.5 Tools You Will Need
No. 2 Phillips screwdriver
1/8" or 3/16" flat blade screwdrivers
Drill and small drill bit assortment
Socket / open-end wrench assortment
Wire cutters / wire stripping pliers
Soldering iron and solder or wire crimping pliers
1.6 Tools You May Need
Depending on the installation, you may also need:
File
Tin snips
Center punch
Sheet metal tools
Insulating tape
Wire spade lugs
Wire crimp connectors
1.1875" and 1.625" hole saw or chassis punch
Volt/ohm-meter
