PCL 600
Operators Manual
v 2.0
10
2 Safety
The machine is designed to cut metal profiles using a plasma torch. The machine should only be used for
industrial applications as outlined in chapter 1.1: Intended use of the machine. Care must be taken when
loading material on to the machine. Always place the robot in the ‘safe’ position before moving material into
or out of the cutting area.
2.1
Qualification of personnel
The machine must only be operated by instructed operators and repaired or maintained by instructed
mechanics.
Risks can especially be caused when the machine:
is operated, maintained or cleaned by inexperienced or non-instructed personnel.
is operated, cleaned or maintained insufficiently.
is used for purposes other than described in chapter 1 Introduction.
Operators and mechanics must:
read and understand chapter 2 of this manual: Safety.
have sufficient knowledge to carry out the activities on the machine.
have knowledge of the presence and working of the emergency stop mechanism of the machine.
have knowledge of the presence and working of all other safety facilities of the machine.
have knowledge of their specific tasks and authorizations.
avoid all activities that are dangerous to the health.
avoid all activities that can cause damage to the machine and the products of the machine.
Operators and mechanics have to make sure that:
the area surrounding the machine is clean and free of persons, tools and other (flammable) objects or
liquids.
the machine is only operated when the machine is in good condition.
the machine is only operated when the provided protective covers are correctly installed at the correct
locations.
CAUTION!
Before operating the machine check that there is no oil leakage in
the vicinity, this may cause a slipping hazard. Remove all materials
from the vicinity of the machine that could cause a tripping hazard.
