Henny Penny LOV LVG-102, Technical Manual

Page: 44 / 98

Model LVG-102, 103, 104
7-5
7. Using an 11/16” crows-foot, remove large high limit fitting
in vat wall, and pull high limit from inside the control area.
8. Install new high limit in reverse order and restore power to
unit.
9. Fill vat by pressing and holding a button until
*FILTER* *MENU* shows in the display. Then once
“1.AUTO FILTER” shows in the display, press 4
times until “5.FILL POT FROM DRN PAN” shows in
display. Press √ button; “FILL POT FROM DRN PAN”
“YES NO” displays. Press √ button again, display shows
“FILLING” “STOP?”and oil fills vat. Press √ button again,
display shows “FILL POT FROM DRN PAN” “YES NO”.
When vat is full, press X twice to return to normal
operation.
7-4. HIGH TEMPERATURE
LIMIT CONTROL
(Continued)
This is a covered rocker switch, which in the ON position,
sends power to all the controls and filter motor.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
1. Remove control panel.
2. From the inside of control area, squeeze in on the tabs on
the back of the switch and push switch out the front of the
control area.
3. Label and remove wires from the switch.
Checkout:
4. Check across the two sets of terminals of the switch for
continuity. With switch in the ON position, circuit should
be closed. With switch in the OFF position, circuit
should be open.
If the switch is found to be defective, replace it by connecting
the wires to it (as labeled) and push new switch into place.
7-5. MAIN POWER SWITCH
Feb. 2011