HEIDENHAIN TNC 426 CB, Technical Manual

Page: 81 / 1135

December 2001 Software Releases 2 – 71
NC software
280 476-19 (export
version 280 477-19) Release: 07/01
n
MP2180 has been expanded into MP2180.0 to MP2180.8.
n
MP2600.x: Input range expanded
n
MP7160 bit 3: IPC and acceleration feedforward for Cycle 17 and 18
n
New error message Actual position saved <axis> when a calling of
Module 9146 is not permitted
n
In the
MP7530
column and in the
TEMPCOMP
column of the description tables
for the swivel axis geometry, a maximum of 16 variables can be used.
n
Module 9120 and 9123: Error code 6 (feed rate not permitted) added
n
New code word
REMOTE.PLCPASSWORDFORCED =
for OEM.SYS, in order to
permit machine backup, full backup and setup only with the code word
defined with
PLCPASSWORD =
.
NC software
280 476-20 (export
version 280 477-20) Release: 08/01
NC software
280 476-21 (export
version 280 477-21) Release: 11/01
n
MP1152: I3 (control-is-ready signal acknowledgement) is passed on directly
to the NC, or is first processed by the PLC
n
The machining plane position indication (MP7500 bit 1 = 1) has been
expanded by the following swivel-axis combination:
Swivel head and rotary table: axis sequence B variable, A variable (tool
axis Z)
n
FAILTEST code number for testing an internal EMERGENCY STOP
n
The power module table was expanded by the following columns: I-N-DC,
T-DC, F-DC, T-AC, F-AC, T-IGBT, I-N-AC-3333, I-N-AC-4000, I-N-AC-5000,
I-N-AC-6666, I-N-AC-8000 and I-N-AC-10000. The columns currently have no
function.
n
The motor table was expanded by the following columns T-DC, F-DC, T-AC
and F-AC. The columns currently have no function.
n
In the
Machine-parameter programming
mode, the DELETE ALL and
SELECT soft keys after the DEL/SEL SETUP soft key were switched.