HEIDENHAIN TNC 426 CB, Technical Manual

Page: 570 / 1135

6 – 240 HEIDENHAIN Technical Manual TNC 426, TNC 430
Control in
operation If the control is at work, e.g. executing a positioning movement or an M
function, a symbol resembling an asterisk “*” is shown in the status window.
If a running NC program is interrupted with an external stop key, the control-
in-operation symbol blinks in the status display window.
In the POSITIONING WITH MANUAL DATA INPUT, the PROGRAM RUN,
SINGLE BLOCK and the PROGRAM RUN, FULL SEQUENCE operating
modes, these conditions are reported to the PLC with M4175 and M4176.
To delete or display the control-in-operation symbol through the PLC:
7 7 7 7 Ensure that the control-in-operation symbol is not already blinking or being
displayed by the NC.
7 7 7 7 Enter the command code in Module 9089.
Module 9089 Control in operation
The ”control-in-operation” symbol can be set only if it is not already being
displayed by the NC, since the NC has priority over the PLC. If the symbol is
being displayed by the NC, it cannot be erased.
M4176 is not influenced by the display of the control-in-operation symbol
through the PLC.
Call:
PS
B/W/D/K <Command code>
0: Erase the control-in-operation symbol
1: Display the control-in-operation symbol
CM 9089
PL B/W/D <Error code>
0: Control-in-operation symbol was erased/displayed
1: Incorrect error code
2: Control-in-operation symbol is already displayed by the
NC
3: Control-in-operation symbol is blinking
4: Control-in-operation symbol was not erased because it is
already being displayed by the NC
Error recognition:
Marker Value Meaning
M4203 0 No error
1 Incorrect transfer parameter
Set Reset
M4175 Program interruption, control-in-
operation symbol blinks NC NC
M4176 Control is in operation, control-in-
operation symbol is on or is blinking NC NC