HBM U10M, Mounting Instructions, Page: 27 / 128

27
U10M, U10S
A1385-6.2 en/de/fr HBM
Template: Bridge Sensor
Parameter Value
1)
Unit Rights
level
Explanation
Transducer electrical
signal type Bridge
sensor
ID
Minimum force/weight 0.000 N CAL The physical measurand and unit are
defined when the template is created,
after which they cannot be changed.
Maximum force/
weight 25,000k N CAL
Minimum electrical
value 0.00000m V/V CAL The difference between these values
is the sensitivity according to the
HBM manufacturing certificate or
from calibration.
Maximum electrical
value 2.08123m V/V CAL
Mapping method Linear This entry cannot be changed.
Bridge type Full bridge ID Bridge type.
For HBM's SG‐based transducers,
the bridge type is always full bridge.
Impedance of each
bridge element 350.0 Ohm ID Input resistance according to the
HBM data sheet
Response time 1.0000000
u
sec ID Not relevant to HBM transducers.
Excitation level
(nominal) 5.0 V ID Nominal (rated) excitation voltage
according to the HBM data sheet
Excitation level
(minimum) 0.5 V ID Lower limit for the operating range of
the excitation voltage according to
the HBM data sheet.
Excitation level
(maximum) 12.0 V ID Upper limit for the operating range of
the excitation voltage according to
the HBM data sheet.
Calibration date 1‐Jan‐2005 CAL Date the manufacturing certificate
was created at HBM (or date of last
calibration or entry of TEDS data).
Format: day-month-year.
Calibration initials HBM CAL Initials of the calibrator or calibration
laboratory concerned (max. three
characters).
Calibration period
(days) 730 days CAL Time before recalibration, calculated
from the date specified under
Calibration Date.
Measurement
location ID 0 USR Identification number for the
measuring point (assigned by the
user). Possible values: 0 to 2047
(numbers only). The HBM Channel
Comment template is also available
as a supplement.
1)
Typical values for an HBM U10M 25 kN type force transducer
The user can also write other templates, such as the “Signal Conditioning"
template.