USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
4
The functions and features described in this manual assume that the AquaRite S3 is using the lat-
est firmware version available from Hayward. For the AquaRite S3, a USB port is used for firmware
upgrades. The latest firmware can be found on the AquaRite S3’s product page on the Hayward
website. For instructions on how to upgrade firmware, refer to page 21.
Although the AquaRite S3 is easy to use, it is important to completely read through this manual
before attempting to install, configure and operate the unit.
Features
The AquaRite S3 offers the following features:
•
can generate chlorine using a broad range of salt concentrations from 1200 PPM to 8000 PPM
•
can control and schedule a Hayward Variable Speed (VSP) pump using the internal RS-485
connection, a Pentair VSP using a Hayward HLPMPCONV converter (sold separately) or a single
speed pump using a Hayward Smart Relay (sold separately)
•
can control a gas heater, heat pump or any other heater that uses a low voltage on/off remote
connection (requires Hayward water temperature sensor sold separately)
•
inputs for water and air temperature sensors (temperature sensors sold separately)
•
connection for flow switch used to detect water flow
•
connection for pool cover detection (lowers chlorine production when the pool is covered)
•
can be powered by either 115 or 230 VAC
•
offers recirculation freeze control which turns on the filter pump automatically to prevent freez-
ing (requires Hayward air temperature sensor sold separately)
VSP or Smart Relay
USB for firmware upgrades
Temperature and Pool
Cover Sensors
Heater
Flow Switch
TurboCell
Input Power
Connector
Display Connector