USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
26
Temperature
Use the “+” and “-” buttons to raise and lower the desired heater setpoint. Press “OK” to save the
selection.
Heater ext.
If enabled, the filter extend logic keeps the filter pump running beyond the normal turn-off time until
the pool (or spa) is heated up to the desired temperature setting. Heater extend will NOT cause the
filter pump to turn on, it will only delay the turn off time when the heater is operating. The AquaRIte
S3 must control the filter pump directly (VSP) or through a Smart Relay (single speed pump) to use
heater extend.
Cool down
This feature ensures that the heater cools down before water circulation is stopped.
When enabled,
the AquaRite S3 will continue to run the filter pump for 5 minutes after the heater turns off regardless
of the schedule.
Pool cover Menu
The Pool Cover menu allows you to enable/disable pool cover detec-
tion as well as change pump speed and reduce chlorination when
the cover is on the pool. When the pool cover is closed, chlorine is
not lost to sunlight and bacteria load is typically reduced, requiring
less chlorine. Pool cover detection requires a normally open switch
connection to the AquaRite S3. Refer to your pool cover instructions
for compatibility information.
Cover det.
Use the “+” and “-” buttons to enable or disable pool cover detec-
tion. Press “OK” to save the selection.
Chlorination
This is the high limit of chlorine only when the cover is closed. Use
the “+” and “-” buttons to set the desired level from 0% to 100%,
then press “OK” to save. Note that the pump must be programmed to run (see below). When the
cover is detected, the AquaRite S3 will produce up to, but no more than this setting.
Pump
Use the “+” and “-” buttons to enable or disable the pump while the cover is closed. Press “OK” to
save the selection.
Speed (only shown for VSPs)
You can set a desired pump speed while the cover is closed. Use the “+” and “-” buttons to cycle
through the available speeds, Low, Medium, High and Any.