USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
25
ºF
A
M
A
M
A
M
A
M
A
M
A
M
temp”. If a VSP is used and recirculation freeze protection is enabled, the pump will run at the speed
programmed in the “Filter Pump” section on page 28.
Freeze temp
Use the “+” and “-” buttons to raise and lower the freeze temperature. Press “OK” to save the selec-
tion. If freeze protection is enabled, the pool pump will automatically turn on when the outdoor air
temperature falls below this temperature.
Schedule
When enabled, the AquaRite S3 can run up to 3 schedules per
day. Each schedule can be programmed for a start time, end
time and pump speed (VSPs only). When start time and end time
are the same, the schedule will not run.
Schedule
Use the “+” and “-” buttons to enable or disable schedules.
Press “OK” to save the selection.
Speed
Schedules are numbered 1-3. For each schedule, use the
“+” and “-” buttons to change pump speed from L=Low,
M=Medium, and H=High. Press the “UP” button to advance to
the next schedule. Set speeds on all desired schedules and then
press “OK”. To set the actual speeds for Low, Medium and High
settings, refer to the “Filter Pump” section on page 28.
Time
For each desired schedule, use the “+” and “-” buttons to change start time and end time. Press
“Up” to advance to the next time setting. To prevent a schedule, set the start time and end time to the
same value. When all scheduled times have been set, press “OK” to save. Programmed schedules
will now automatically run.
Heating Menu
(requires water temperature sensor)
Use the Heating menu to enable/disable the heater, set the
temperature, and turn on/off the heater extend and heater cool
down functions.
Heating
Use the “+” and “-” buttons to enable or disable the heater con-
trol. Press “OK” to save the selection.
Speed (only shown for VSPs)
Use the “+” and “-” buttons to select LOW, MEDIUM and HIGH
setting. Press “OK” to save the selection. The is the minimum
speed the pump will run while the heater is in use. This setting
is useful to ensure that the heater receives a sufficient flow rate
to operate regardless of schedule.
