USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
20
Configuration
When all input and pool related wiring is comple
te, replace and secure the front panel. The AquaRite
S3 can now be powered on for the first time. Apply power and wait for the AquaRite S3 to completely
start. Because this is the first time that the AquaRite S3 has been powered on, it will bring you directly
to the initial configuration screen.
The AquaRite S3 uses a Configuration Wizard to assist in the con-
figuration of the AquaRite S3. These screens will prompt you for specific information about your pool
to help set up the operation of the AquaRite S3. Configuring the AquaRite S3 requires knowledge of
all of the connected pool equipment (pool filter pump, heater, etc.).
Navigation and Configuration Wizard
Note that the AquaRite S3 uses 6 pushbuttons to navigate the menu and set values. The functions
of these buttons are shown below.
Use to increase a setting
Use to decrease a setting
Use to make a selection or to enter Main Menu
Use to navigate
Use to navigate
Use to return to previous screen
Language
The AquaRite S3 will support multiple languages. Select the desired language then touch the OK
button to advance.
Time and Units
Format
- Set the desired clock format to a 12hr clock (AM/PM) or 24hr clock (military time). Use the
“+” and “-” buttons to change this value.
Time
- Use the “+” and “-” buttons to change the value and the “UP” and “Down” buttons to move to
the next selection. Set desired Hour, Minute and Seconds and when finished, press the “OK” button
to save.
DST
- Select whether Daylight Savings Time is currently observed in your time zone.
Temp. Units
- Select whether Fahrenheit or Celsius units will be displayed.
Salinity Units
- Salt can be displayed in Parts Per Million (ppm) or Grams Per Liter (g/l). Make the
desired selection.
After making all the selections on this screen, press the “OK” button to advance to the next screen.
+
OK