USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
16
Pool Cover Sensor
If the pool has a motorized cover, the AquaRite S3 can automatically scale back operational limits
(both chlorination setpoint and pump speed) to ensure overchlorination doesn’t occur. The pool cover
sensor must use a normally open switch that connects to the pool cover terminals shown below.
Refer to the pool cover manufacturer’s literature to determine compatibility.
Final Steps
With the previous wiring completed, locate the precut removable foam gasket that can be used to
seal the low voltage exit. Wrap it around the low voltage wiring at the exit of the enclosure (shown
below). Work the gasket into the exit slot until it is fully sealed then re-install the panel and display.
Flow Switch
The flow switch cable plugs into the flow switch connector on the bottom of the AquaRite S3’s enclo-
sure shown on page 4. Ensure that the connector latch “snaps” into place.
TurboCell
The TurboCell should be plugged in AFTER the AquaRite S3 cover panel is installed. Refer to page 4
for the location of the chlorinator cell connector.
AIR
POOL
POOL COVER
Foam Gasket