HATO SWING 400, Assembly And Operation Manual

Page: 10 / 36

5 - Mount the drive on plate A and fix it with the appropriate screw.
6 - Close the gate and remove the pin D by unscrewing it to the end of its stroke.
7 - Screw in the tube D making 1 full turn through 360 °.
8 - Take plate B, insert it into the hole in the pin and rest it on the sash crossbar. Screw in the plates,
taking into account the slope referred to in point 3.
9 - Repeat the above steps for the other gate leaf.
10 - Make electrical connections and install safety devices. Install mechanical end stops.
ATTENTION!
OPERATING THE DRIVE WITHOUT INSTALLED END STOPS WILL VOID THE WARRANTY!
11 - Place the protective cap on the unlocking pin.
ATTENTION!
NOT USING THE MECHANISM CAP
DISCONNECTION WILL VOID
THE WARRANTY!
12 – Maintain a film of aerosol lubricant on the actuator telescope. This is especially important when
the temperature drops below 0 ° C
10