HATO SWING 400, Assembly And Operation Manual

Page: 31 / 36

LED2 blinking three times. 2 blinks indicate
full memory. 1 blink means the end of the
learning time.
After correct programming, we have
another 10s to program the other
transmitters, etc.
To finish the procedure, wait 10 seconds
from the last programming or shortly press
the LEARN button. LED2 will blink and the
receiver will return to normal operation.
LEARN
REMOTE PROGRAMMING OF TRANSMITTERS (FOR SBS
FUNCTION) -HELB9C
Remote programming of the transmitters takes place when a 4-channel transmitter has been
programmed earlier (e.g. type 4E433). The procedure enables programming a new
transmitter for the SBS function.
For approx. 5 seconds, simultaneously hold
down buttons C and D of the programmed
transmitter.
C D
Release buttons C and D ( LED2 is on).
C D
Within 5 seconds, press the button of the
transmitter you want to program. (Correct
programming is signaled by 3 blinks of
LED2 )
Validate the operation. After pressing the
programmed button, the gate should start.
REMOTE PROGRAMMING OF TRANSMITTERS (SBS OR WICKET)
-HELB9C
Remote programming of the transmitters takes place when we have previously programmed
a 2 or 4-channel transmitter (e.g. type 4E433). The procedure enables programming of a
new transmitter for the SBS or WICKET functions.
Hold buttons A and B of the programmed
transmitter simultaneously for approx. 5
seconds
A B
Release buttons A and B ( LED2 is on).
A B
Within 5 seconds, press the button of the
programmed transmitter that controls the
SBS or WICKET function.
ATTENTION! The new transmitter will be
assigned to the function for which the
pressed button is programmed.
LED2 will start blinking rapidly.
31