HATO SWING 400, Assembly And Operation Manual

Page: 2 / 36

completely before starting the assembly. The manual applies only to the drive for the gate, not to the
entire device which is the `` automatic gate ''.
RECOMMENDATIONS AND PRECAUTIONS FOR INSTALLATION
► These operating instructions are intended only for properly licensed installers, who know the
rules of good engineering practice and safety devices to protect against hazards, installed in gates,
doors and motorized gates (observe the applicable standards and regulations).
► Use the product as intended.
► Only install the drive in correctly fitted gates.
► Before starting the installation, the installer should carry out a risk analysis for automatic end
closure and the protection of the entire system (in accordance with EN 12453 and EN 12445).
► Wiring of individual electrical components that are part of the automatic closing system (e.g.
photocells, flashing lights, etc.) should be made in accordance with EN 60204-1 as amended by this
standard in clause 5.2.2 of EN 12453.
► The installation must be carried out with basic ESD protection.
► All work related to the proper functioning of the device (connection, start-up, operation) must be
carried out in accordance with the applicable regulations in the field of electrical equipment operation
and in accordance with health and safety regulations as well as with the standards in force in a given
country.
► During any welding work in the vicinity of the gate, disconnect the gate drive from the power supply
and disconnect the electronic circuits.
► Before carrying out any work on the drive, disconnect the power supply and secure it against being
switched on again. This also applies to battery operation.
► Before starting the installation, check the mechanical condition of the gate: it should not sway
excessively, it should move easily and smoothly. It must not tilt when opening or closing and must be
level.
► Be especially careful during assembly! The controller uses 230Vac voltage (life and health
threatening).
► During installation, keep the gate away from children, handicapped persons and motor vehicles.
► Installation, connection and initial commissioning of the gate drive may be performed only by
qualified personnel.
► The methods of electrical installation as well as its protection against electric shock are defined by
the applicable standards and legal regulations.
► Do not connect the drive to the power supply earlier than specified in the manual, failure to do so
may result in electric shock.
► All fixed control elements should be located near the gate, but away from moving parts and out of
the reach of outsiders.
► The power line should be protected against the maximum current with locked rotor.
► The controls must be mounted at a minimum height of 1.5 m above the ground and out of the reach
of the moving parts.
► The gate actuator must be connected to a control unit equipped with torque control that provides
protection against crushing in accordance with the provisions of EN 12453 - EN 12445.
► Install the safety devices (photocells, safety edges, curtains, etc.).
► Installation of a possible pair of photocells: the photocell beam should be at a height not exceeding
70 cm from the ground and at a distance from the plane of leaf movement that does not exceed 20
cm. After completing the installation, check that the photocells are working properly in accordance with
the provisions of clause 7.2.1 of EN 12445.
► If there is an entrance door (wicket) within the range of operation of the gate, it must be closed
when the gate is in motion - install an additional safety device to prevent movement when the door is
open.
► Check that the assembly is correct and that all bolts and nuts are tightened.
► Carry out a test of all safety features and a functional test.
► Perform acceptance measurements for compliance with the applicable standards.
► Check the effectiveness of the PE circuit.
► Prepare a report on the acceptance procedure.
► Issue the EC declaration of conformity.
► Inform and train all door users about safety recommendations, periodic inspections and
2