HATO SWING 400, Assembly And Operation Manual

Page: 27 / 36

OR
To assign positions manually, press the SBS
sequential control button for less than 3s or
the transmitter button assigned to this
function.
LED1 will turn off
or SBS
Press the SBS sequence control button for
less than 3s or the transmitter button
assigned to this function.
or CH1
LED1 will blink 3 times to confirm that the
settings have been saved. The controller will
return to normal operation.
ATTENTION!
To return to the normal operation without
saving the settings, press the STOP or
SETUP button for less than 3 seconds. The
gate will stop and LED1 will blink once.
SETUP OR
ATTENTION!
If you do not want to use the deceleration
function, during programming, when the
motor works with the power set on the
FORCE potentiometer, do not press the SBS
button and wait for the gate to hit its limit
switches.
LUB
In the manually set end position, press the
SBS button or the transmitter button twice
within 2 seconds.
OL/CL
ATTENTION!
After each adjustment of the engine power
on the FORCE potentiometer, the engine
operation programming procedure must be
repeated.
SOFT START FUNCTION
(from version HELB9C REV 1.3)
The SOFT START function enables a smooth start of movement. After the start, the motors
run at reduced speed for a programmed time, and then with the power set on the
potentiometer.
ATTENTION!
The SOFT START time has an effect on determining the deceleration position and must
be programmed prior to programming the motors' operation.
We set it in the range from 0s to 10s in 1s step. Default: 0s
Press and hold SETUP button.
SETUP
LED1 will turn on, turn off, turn on and turn
off again.
27