HATO SWING 400, Assembly And Operation Manual

Page: 29 / 36

seconds, and the M1 leaf is controlled from the WI input.
To activate the ELECTRIC DOOR LOCK
function, set the CH2 / EZ switch to the ON
position.
To turn on the transmitters control
function , set the CH2 / EZ switch to the
OFF position.
CLEARING ALL TRANSMITTERS
When the memory is full or we have problems with programming the transmitters, we
must perform the deletion procedure. We recommend that you perform this procedure
first right after installing the receiver.
Hold down the LEARN button.
LEARN
The LED2 will turn on, then turn off and
flash.
Release the LEARN button. The LED2 will be
on.
LEARN
Within 3 seconds , hold the LEARN button
again.
LEARN
The LED2 will blink 3 times .
Release the button. The deletion procedure
is complete. When the diode stops blinking,
the receiver will return to normal operation.
LEARN
CLEARING TRANSMITTERS FROM A PARTICULAR FUNCTION
It is possible to delete transmitters only from a particular function ( SBS or WICKET/CH2 ).
Enter the procedure for programming the
transmitters for the given function.
TRANSMITTER PROGRAMMING
PROCEDURE
While waiting for the transmitter code,
press and hold the LEARN button.
LEARN
The LED2 will blink 3 times.
Release the button. When the diode stops
blinking, the deletion procedure is finished
and the controller will return to normal
operation.
LEARN
PROGRAMMING OF TRANSMITTERS
A maximum of 32 transmitters with a Keeloq dynamic code can be programmed. Each
button must be learned separately. It is possible to change the buttons controlling a given
function of an already programmed transmitter by re-programming another button. When
programming changes, remember that when programming for a given function, a button
29