Propeller Owner’s Manual
140
INTRODUCTION
61-00-40
Page 1-5
Rev. 2 Jun/12
(7) As necessary, use a soft, non-graphite pencil or crayon to
make identifying marks on components.
(8) As applicable, follow military standard NASMS33540 for
safety wire and cotter pin general practices. Use 0.032
inch (0.81 mm) diameter stainless steel safety wire unless
otherwise indicated.
CAUTION:
DO NOT USE OBSOLETE OR
OUTDATED INFORMATION. PERFORM
ALL INSPECTIONS OR WORK IN
ACCORDANCE WITH THE MOST
RECENT REVISION OF THIS MANUAL.
INFORMATION CONTAINED IN THIS
MANUAL MAY BE SIGNIFICANTLY
CHANGED FROM EARLIER REVISIONS.
USE OF OBSOLETE INFORMATION
MAY CREATE AN UNSAFE CONDITION
THAT MAY RESULT IN DEATH, SERIOUS
BODILY INJURY, AND/OR SUBSTANTIAL
PROPERTY DAMAGE. FOR THE MOST
RECENT REVISION LEVEL OF THIS
MANUAL, REFER TO THE HARTZELL
PROPELLER INC. WEBSITE AT
WWW.HARTZELLPROP.COM.
(9) The information in this manual supersedes data in all
previously published revisions of this manual.
(10) The airframe manufacturer’s manuals should be used in
addition to the information in this manual due to possible
special requirements for specific aircraft applications.
(11) Approved corrosion protection followed by approved paint
must be applied to all aluminum blades.
(a) For information concerning the application
of corrosion protection and paint, refer to the
Maintenance Practices chapter of this manual.
(b) Operation of blades without the specified coatings
and finishes, i.e., “polished blades”, is not permitted.
Summary of Contents for HC-D2MV20-3 Series
Page 6: ...Propeller Owner s Manual 140 Page 4 Nov 02 61 00 40 MESSAGE This page is intentionally blank...
Page 202: ...Page 8 2 Nov 02 RECORDS61 00 40 Propeller Owner s Manual 140 This page is intentionally blank...
Page 204: ...Page 8 4 Nov 02 RECORDS61 00 40 Propeller Owner s Manual 140 This page is intentionally blank...