Propeller Owner’s Manual
140
INSTALLATION AND REMOVAL
61-00-40
Page 3-52
Rev. 3 Feb/14
(d) The spool should extend 1.31 inches (33.3 mm)
beyond the valve casting.
NOTE: To obtain the proper dimension, remove the
link, grip the small end in a vise, and bend it
until the distance between the two holes on
the link has changed the required amount to
obtain 1.31 inches (33.3 mm) on the spool
length.
(e) Pull the cockpit propeller control into full high pitch and
force the piston back to check for washers, screws,
or safety wire that may prevent the piston guide arms
from touching the outer diaphragm ring
B-120 or high pitch position.
(3) Propeller Installation
(a) Clean the engine shaft with an approved solvent.
(b) Oil the engine shaft with engine oil.
(c) Install the spacer(s) and rear cone (Table 3-1).
NOTE: Install the same number of spacers as
previously installed if the same propeller
is reinstalled. If a different propeller is
installed, install one spacer. The need for
additional spacers will be determined during
the static RPM checks after the propeller is
installed.
WARNING:
USE A SUITABLY RATED SLING TO
SUPPORT THE WEIGHT OF THE
PROPELLER ASSEMBLY DURING
INSTALLATION.
(d) With a suitable crane hoist and sling, carefully move
the propeller assembly to the aircraft engine shaft.
(e) Install the propeller hub on the engine shaft.
Summary of Contents for HC-D2MV20-3 Series
Page 6: ...Propeller Owner s Manual 140 Page 4 Nov 02 61 00 40 MESSAGE This page is intentionally blank...
Page 202: ...Page 8 2 Nov 02 RECORDS61 00 40 Propeller Owner s Manual 140 This page is intentionally blank...
Page 204: ...Page 8 4 Nov 02 RECORDS61 00 40 Propeller Owner s Manual 140 This page is intentionally blank...