Propeller Owner’s Manual
140
INSTALLATION AND REMOVAL
61-00-40
Page 3-31
Nov/02
(k) With the propeller blades at high pitch, align the push
rods and sleeves with the guide collar bushings by
rotating the propeller hub or jack plate unit relative to
each other.
(l) Slide the push rods and sleeves through the guide
collar bushings by rotating the blades to reverse pitch.
CAUTION:
NEVER USE FORCE TO START THE
HUB NUT.
(m) Thread the hub nut onto the engine shaft. Make sure
the threads have engaged properly.
(n) Torque the hub nut on the engine shaft. Refer to
Torque Values Table 3-2.
(o) Install a washer and nut on the end of each push rod
protruding through the guide collar bushings
(p) Torque the piston rod nuts until in accordance with
Table 3-2.
(q) Rotate the blades by hand to reverse pitch position.
NOTE: When the propeller is in reverse pitch
position, the reverse stop washer will be
pinched between the guide collar and the
shoulder on the sleeve.
(r) Slowly turn the propeller on the engine to verify if there
is clearance between the blade clamp assemblies and
the valve assembly.
(7) Repeat steps 4.D.(5) through 4.D.(6)(o) until clearance
between the blade clamp assemblies and the valve
assembly is achieved.
Summary of Contents for HC-D2MV20-3 Series
Page 6: ...Propeller Owner s Manual 140 Page 4 Nov 02 61 00 40 MESSAGE This page is intentionally blank...
Page 202: ...Page 8 2 Nov 02 RECORDS61 00 40 Propeller Owner s Manual 140 This page is intentionally blank...
Page 204: ...Page 8 4 Nov 02 RECORDS61 00 40 Propeller Owner s Manual 140 This page is intentionally blank...