Hartzell HC-D2MV20-3 Series, Owner'S Manual And Logbook

Page: 102 / 204

Propeller Owner’s Manual
140
INSTALLATION AND REMOVAL
61-00-40
Page 3-38
Nov/02
(19) Replace the fuel line with AN6260-6-29 hose and reroute
the hose under the engine cylinders with (2) AN742D12C
clamps.
(20) Install the 6-C6BX-S elbow on the fuel line fire wall T-fitting
and install the original fuel line.
(21) Remove the two outboard studs on the engine pad and
install the longer studs A-148-2, as shown in Figure 3-6.
(22) Reinstall the gasket 352061 on the pad of the engine, as
shown in Figure 3-6.
(23) Replace the gear shaft in the adapter (Continental P/N
40722).
(24) Replace this assembly in the engine, aligning the 3/16 inch
(4.76 mm) hole with the hole in the “T” drive, as described
in Figure 3-6.
(25) Install the new AN4045-1 gasket on the adapter B-145
(Reworked Continental Engines P/N 40722).
(26) Install the governor “T” drive-fuel pump assembly on the
engine pad using (4) B-3808-4 nuts and (4) B-3851-0463
washers.
(27) Install a new B-6642-1 gasket on the fuel pump pad of
C-137-1B “T” drive.
(28) Install a heat shield P/N 530371a new B-6642-1 gasket
between the heat shield and the fuel pump. Refer to
Figure 3-5.
(29) Install the fuel pump on the “T” drive with the P/N 530371
heat shield between the fuel pump and the “T” drive. Refer
to Figure 3-6.
(30) Remove the caps from the opening of the fuel lines.
(31) Connect the AN6260-6-48 hose to the fitting in the “T”
drive and route it over the center of the engine, through
the 1 inch (25.4 mm) diameter hole in the baffling, with
grommet AN931-11-16.