6-2
888-2685-001
12/24/07
WARNING: Disconnect primary power prior to servicing.
Ranger Commissioning Manual
Section 6 ISP (In-System Programming)
6.2
Installing the ISP Program
The In-System Programming (ISP) application, HarrisISP.exe, is a Windows based
software program. The main requirements are a Windows based PC and an open COM
port.
To install the HarrisISP.exe program simply double click the Setup.exe program located
on the CD-ROM in the directory D:\Firmware\Isp\ as shown in Figure 6-1 or use the
RUN command in the START menu.
Figure 6-1 CD-ROM ISP Directory
Simply follow the on screen instructions and do not change the paths where
the program wants to be installed. When finished you should have the Harris
ISP icon on your desktop, like the one to the right.
6.3
ISP Procedures
The ISP procedure is basically the same for all of the control boards (Main Controller,
RF monitor, PS monitor and External I/O) but is slightly different for the PA Module
controller. The main differences are the serial connection point and the baud rate. This
means there are 2 ISP procedures:
•
Control System ISP
•
PA Module ISP
Double Click to Launch Install program
Summary of Contents for Ranger Series
