Chapter 3 – Installation
Hardy H6800 Series Application Controllers User Guide
23
3.1 Planning Your Installation
3.1.1 Hardy Field Service
Hardy Process Solutions provides local field service for all scales and weighing equipment.
Hardy’s factory trained technicians can perform service on all Hardy equipment as well as
most other manufacturers’ systems. Enabled by the Hardy Process Toolbox, our technicians
spend less time onsite, saving money and reducing downtime.
Services include the following (click a service below for more information):
•
•
•
Product, Service, and Controls Workshop
•
•
Calibration & Preventive Maintenance
To request any of these services, or to discuss your needs with a trained Hardy Service
Agent, call 800-821-5831 option 4 between 6:30 AM and 5:30 PM PST. For emergency
downtime service after hours, leave a message in our emergency mailbox and your call will
be returned promptly, or email us at
Note:
Because the HI6800 Series Application Controllers are part of a larger
system, their installation may depend on other system components. Refer to
any additional information furnished by Hardy or vendors of other
components used in the system (PLC systems, load cells, scales, etc.).
3.1.2 Required Tools
The following tools are required to install the HI6800 Series Application Controller.
•
A small flat blade screwdriver (2 mm) for terminal blocks
•
A medium flat blade screwdriver (4mm) when using AC power supply.
•
A center punch and a drill with a 13/64-inch (5-mm) bit and a 1.25-inch (32-mm) bit when
installing with a display.
•
A jeweler’s screwdriver if lengthening of the display cable is required for remote-display
installations.
