To charge your vehicle, proceed as follows:
1.
Check the LED status indicators at the top of the cPP2:
When the charging pole is ready for operation, the LEDs on both sides of the pole light
up green.
2.
Open the charging socket on the vehicle.
3.
Plug the charging coupling of the charging cable into the charging socket on the
vehicle. The vehicle must be parked so that you can easily reach the socket on the
vehicle.
The cable
must not
be under tension during the charging process.
4.
Open the cover of a charging socket on the cPP2 and insert the type 2 charging plug.
NOTE!
If you operate your charging station with RFID authentication or an OCPP
backend, please note points 5 and 6. Otherwise, the charging process starts
immediately after plugging in. (The LED changes from "green" to "yellow"
(vehicle connected) to "blue" (charging active).
5.
Log on to the charging station with a valid RFID card (one of the 5 RFID cards supplied
ex works). To do this, hold the card in front of the charging station's card reader for
approx. 3 seconds. A short signal tone will sound to indicate that the card has been
successfully recognised.
Immediately afterwards, another tone will sound:
•
short tone (ca. 1 second) for card accepted
•
long tone (ca. 3 seconds) for card rejected
More information about the RFID module on page 28.
6.
Start of the charging process
In the standard configuration, the charging process starts immediately after the RFID
card has been successfully authenticated. When the charging process starts, the colour
of the status LED of the corresponding charging socket changes from yellow to blue.
7.
The charging process is usually only terminated by the vehicle. The LED status changes
from blue to yellow. After the charging process is completed, first pull the cable out of
the socket on the vehicle and then out of the Type2 socket on the charging pole. If the
vehicle is not 100% charged in this case, please check the settings in your vehicle. You
usually have the option of setting a charging limit (e.g. 80%) in the vehicle's on-board
computer.
Installation and operating manual
cPP2
charging pole
Version: 1.0.2
26