RFID module
The RFID module provides user identification for restricting or enabling the charging
process for an authorised group of users.
Five RFID cards are included in the scope of delivery. These are stored in the charging
pole's database ex works and are required to activate the charging process.
During normal operation, the LED on the RFID module flashes
continuously for a short time (6 s interval). The flashing indicates
that RFID is ready for operation.
If you would like to log on to 2 charging sockets at the same
time, please unplug one of the charging cables and log on to the
two charging outlets one after the other.
If you have connected a charging cable and want to unlock it,
you must hold a valid RFID card against the module.
Should you wish to log on to several charging sockets at the same time, please plug in
the charging cables one after the other and log on to each charging outlet individually.
Once the LED lights up for 1.5 seconds, the card has been recognised and is stored in the
database. The charging process is initiated.
In case your RFID card was not accepted, wait a moment and try again. If the charging
station is still not activated, the card may be defective or not stored in the database. In
this case, contact your sales partner.
For more information on the charging process, see page 25.
Installation and operating manual
cPP2
charging pole
Version: 1.0.2
28