Hardi NAVIGATOR VPZ, Instruction Book

Page: 142 / 204

6 - Maintenance
142
10 Hours Service - CycloneFilter
Servicing the Filter
1.
Turn the pressure SmartValve towards .
2.
Unscrew the filter lid (A).
3.
Lift lid and filter (B) away from the housing.
4.
Turn the two locks (C) outwards to unlock the filter from the lid.
5.
Separate filter from the integrated filter guide in the lid. Clean the
filter.
To Reassemble
1.
Grease the two O-rings on the lid/filter guide. Due to small space
at the lid, use a paintbrush to apply the grease.
2.
Fit the filter onto the recess (which may not be greased) in the
lid/filter guide.
3.
Turn the two locks (C) inwards to lock the filter into position.
4.
Place the filter/filter lid into the housing and screw the lid, until it
hits the stop.
±
WARNING! Always wear protective clothing and gloves, before servicing the filter!
€
DANGER! The pressure SmartValve must always be turned to , before opening the CycloneFilter! If not, the
spraying liquid can hit you, when opening the filter, and the main tank content will drain away!
10 Hours Service - In-Line Filter
If PrimeFlow is installed in the spray boom, these filters are not included.
If the boom is equipped with In-Line filters, unscrew the filter bowl to
inspect and clean the filter. When reassembling, the O-ring should be
greased.
Alternative filter meshes are available. See the section “Filters” on
page 189.
±
WARNING! Be careful not to splash out liquid, when unscrewing
the filter bowl.
Always wear protective clothing and gloves, before servicing the
filter!
10 Hours Service - Nozzle Filters
The filters are located in the nozzle holder.
Check the filter condition and clean the filter.