HappyJapan HCH Plus, Instruction Book

Page: 272 / 355

-FO -14
4-5
HOOPING FABRIC
4_5 N101
8. Remove the One-point frame from the Frame
setting base.
9. Set frame on Cap frame driver with opening pocket.
Please confirm bed of machine is entered into
pocket.
Then, push the holder lever in the 2 places shown,
and place the One-point frame on so that the center
guide of the Cap drive frame assembly fits into the
One-point frame notch.
Confirm that the Frame is firmly seated on the
cap drive frame assembly without any gaps.
If there is a gap between the Frame or the cap
drive frame holding lever doesn't go into the hole
of the Frame, loosen the set screw on the hold
lever for adjustment.
Hold lever
Center
guide
Cap drive
frame
One-point
frame
W-clip
CAUTION: To avoid problems.
Do not power machine on, when frame is placed with
fabric.
Machine may move wider area than embroidery area
of frame and damage frame, machine and fabric
Thick fabric Thin fabric
Change the number W-clip
7. Fasten around frame with bundled W-clips.
Use more W-clips when you make embroi-
dery on stretch fabric or thin fabric.
Especially large design or many filling
stitches is required, fabric may shrink.