HappyJapan HCH Plus, Instruction Book

Page: 132 / 355

-CU -145
13-B
FRAME CONFIRMATION
20_B T601
Frame data constitution
Type = [Type of data]
Name = “[Name of frame]”
Form = [L00],[L10],[L20],[L30],[L40],[L50],[L60],[L70],[L80],[L90] (Frame shape)
Type : Select type of data by following number.
1 : Frame size 2 : Possible embroidery size
Note: If select “1”, machine will memory reduced size for Presser food diameter
automatically.
If select “2”, machine will memory exactly same size as can embroider it on.
Name : Naming the your User-custom frame. Pick up to 10 letters up with a “mark.
Form
: Refer the above figure. Please fill it out every 10 degrees of dimensions to the inside of
the frame in a frame heartily. (20 to 500mm)
Fill it out length from point from No. L00 till L90 total 10 points size using “, “ between the
each size data.
If your frame shape is Round, the every 10 points length frame size data should be
same.
If you select Type (Type of data) “2”, please put length data of L00 and L90 only.
END : Please fill out the line of the last of data. Please make entry of “END” by all means.
Please use half width character for the length data.
Please cut off the decimal of the length.
Example: 102.3mm -> 102
How to make frame size data of your User-defined frames (6 ~ 60)
We need to use text edit software of PC like “WordPad” and make frame size data with following
constitution, then entry the data to your machine.
Fig. 1
Center of
user-defined
frame
Fig. 2
90°
0°
L90
L00
90°
0°
L10
L20
L30
L40
L50
L60
L70
L80 L90
L00
Type = 1 (Type of data) Type = 2 (Type of data)
Center of
user-defined
frame