-CS -29
5-4
PREPARATION OF PATTERN DATA
Connecting to a PC by Serial or USB connection
This embroidery machine will allow you to read design data from a connected PC.
A Serial cable or a USB cable can be used for the connection.
Serial connection
Connect the serial cable between the serial port (RS-232C) of the machine and the serial port of
the PC.
Reading embroidery pattern data from the PC
Designs can be transferred to the machine along with some functions by using the "Happy Link"
software.
Please refer to the “Happy Link” software manual for instructions.
5_4 FA27
USB connection (based on the USB 1.1, 2.0)
Connect by USB cable between USB port of the machine and USB port of the PC.
RS-232C
Serial port
USB
USB port
CAUTION: To avoid problems.
Make sure that power source of machine and PC are off when connecting serial cable.
When you connect the USB cable, make sure that the machine is powered and set into drive mode (lamp
will be green), and that the PC is also turned on.
After recognizing USB in your PC, start-up the "Happy Link".
Please refer to instruction book of "Happy Link" for more precise information.
