-CS -39
P.FOOT
T.CUT
MENU
FORWARD
ENT.
P.FOOT
T.CUT
MENU
FORWARD
ENT.
P.FOOT
T.CUT
MENU
FORWARD
ENT.
P.FOOT
T.CUT
MENU
FORWARD
ENT.
P.FOOT
T.CUT
MENU
FORWARD
ENT.
P.FOOT
T.CUT
MENU
FORWARD
ENT.
5-14
PREPARATION OF PATTERN DATA
5_14 D610
Area ovr Cancel
OK
[MODE] Refere
On
Area ovr Cancel
OK
NOW LOADING•••
C
D
B
[MODE] Refere
On
[MODE] Off
[LETTER] Mode
35
36
F
If when you select “On” the following is
displayed.
"Area ovr"... Line length will be too long.
If resetting is needed
B. Press the "ENT." button with the cursor
pointed at "Cancel".
You will be back to #33 above.
Reset the line length again as on page.
5-11 or.
Change the letter size selection as shown.
5-12
If it is acceptable to increase the size as shown
C. Select "OK" by use of the “Down" arrow"
button.
D. Press the "ENT." button.
"NOW LOADING •••" will be appear, new pattern
data will be made and then you will return to
drive mode.
First 8 letters will be shown as the name of the
pattern which you have made by letter selection.
The distance between the letters will be set to
0.8 mm.
A
ID:15 Nd: 3
FLOWER
If the following is displayed in “Review”
mode.
"Char data not found!"......the letters you have
selected are not available.
F. Press the "ENT." button.
The status will be back to procedure #33.
Set the letter selection. 5-10
E
Char data
not found!
Select the review mode “off”
35.Use the “Down” arrow button to point the
cursor to "OFF" at procedure #33.
36.Press the "ENT." button.
The status will be back to procedure #26 as
above.
Please complete the steps from #27 to reconfirm
your selections.
Please reset items from #33 to Review mode
(ON).
All the selected settings will be deleted when the power source is turned off.
Please be careful when making embroidery letters.
G
