-CS -39
5-9c
PREPARATION OF PATTERN DATA
5_9c H701
FORWARD
P.FOOT
T.CUT
MENU
ENT.
Name:FLOWER_
NOPQRSTUVWXYZ
FORWARD
P.FOOT
T.CUT
MENU
ENT.
Name:FLOWERS
NOPQRSTUVWXYZ
FORWARD
P.FOOT
T.CUT
MENU
ENT.
Name:FLOWERS
0123456789 -!
FORWARD
P.FOOT
T.CUT
MENU
ENT.
[WRITE] (ID:10)
14 FLOWER
10.When not changing a design name, it
progresses to operation of step #14..
For changing a design name,
or
of a needle change button is pushed, and
the beam to change is chosen.
11.The arrow button of the right or the left is
pushed, the cursor of a character palette is
moved, and a character is chosen.
If the arrow button of a top or the bottom is
pushed, letter pallet will change.
12.Press the "ENT. button".
The character chosen by letter pallet is inputted
into a design name.
The maximum number of characters in a design
name is eight letters or numbers.
13.Operation of 10. to 12. is repeated, and a
menu button will be pushed if a design
name is changed.
Or of letter pallet "!" (decision) is chosen.
14.Press the "ENT. button".
After displaying it as ÅgWriting data-Åg,
the beginning is ended and it will be in the state
of choosing other design data.
When writing out other design data continuously,
it progresses to the procedure of 6.
It is as follows when the same name is in
the memory media writing out handle data.
It is displayed.
FORWARD
P.FOOT
T.CUT
MENU
ENT.
-
+
Name:FLOWER_
0123456789 -!
If a space is chosen,
the character of the cursor of
a handle name will be deleted.
When overwriting, a lower arrow button is
pushed, cursor is united with "O.K." and
an execution button is pushed.
When changing a design name, an execution
button is pushed and it progresses to operation
of 10.
15.Finally, Press "MENU" button until the green
lamp on the control box glows.
When a green light is showing, It means you are
in the Drive mode and you can start sewing.
[WRITE] Rename
Same! OK
FORWARD
P.FOOT
T.CUT
MENU
ENT.
ID:18 Nd: 4
BIRD
G
10
12
13
14
15
11
