32
Hangar 9 Pulse 125 ARF Assembly Manual
Step 4
Slide the spinner backplate over the propeller adapter. It
may be necessary to enlarge the hole in the center of the
spinner backplate using a tapered reamer so it will fit on the
propeller adapter.
Step 5
Slide the propeller on the propeller adapter. The small
standoffs on the spinner backplate will help in aligning the
propeller.
note
: It may be necessary to enlarge the hole in the
center of the propeller using a tapered reamer so it will
fit on the propeller adapter.
important
: Always balance your propeller right before
mounting it to prevent vibrations that could damage the
airframe or motor bearings.
Step 6
Secure the propeller using a box wrench and the hardware
from the adapter.
Step 7
Secure the spinner cone to the backplate using two 3mm x
10mm self-tapping screws.
Final Assembly
Required Parts
Fuselage
Canopy
Wing panel (left and right)
Wing bolt plate
Aluminum wing tube
6mm x 40mm nylon wing bolt (2)
Tools and Adhesives
Canopy glue
Medium grit sandpaper
Paper towel
Rubbing alcohol
Low-tack tape
Step 1
Use medium grit sandpaper to lightly sand the inside edge
of the canopy where it contacts the fuselage. Use a paper
towel and rubbing alcohol to remove any oil or debris after
sanding. Apply a thin bead of canopy glue to the inside edge
of the canopy. Use low-tack tape to hold the canopy securely
on the fuselage until the glue fully cures.
