9
Hangar 9 Pulse 125 ARF Assembly Manual
Step 4
After preparing the rudder and elevator servo with the
appropriate hardware, secure them in the radio tray using
the screws provided with the servos.
Step 5
Remove the covering from the side of the fuselage to mount
your particular switch. There are a few different locations, so
choose the correct one for your application.
Step 6
Wrap the receiver battery in foam and secure it in position
using a hook and loop strap (not included).
Step 7
Plug the rudder and elevator servo leads in the correct ports
of your receiver. Also plug the aileron Y-harness and lead
from the switch harness at this time.
Step 8
Wrap the receiver in foam and secure it in position as
shown.
note
: The remote receiver will be mounted later in
the manual. Its location will be determined by your
particular motor selection.
Step 9
Remove the clevises and nuts from the 27.5-inch (698mm)
and 28.5-inch (724mm) linkage wires. Set the hardware
aside so it doesn’t get lost.
