24
Hangar 9 Pulse 125 ARF Assembly Manual
Step 2
Attach the fuel tube designated for the inside of the tank
to the straight brass tube. On the other end of the fuel line
attach the clunk.
Step 3
Insert the stopper on the tank. Make sure the clunk can
move freely inside the tank by having the clunk 1/4-inch
(6mm) from the back of the tank. If the clunk does not move
freely you may experience fuel draw problems. Remove the
stopper and shorten the fuel tube slightly; check and repeat
until it can move freely inside the tank.
Step 4
Use a 2mm x 12mm machine screw and 2mm locknut to
secure the stopper clamp around the stopper. This will keep
the stopper secure on the neck of the fuel tank.
Step 5
Attach the fuel line to the clunk and vent lines of the tank.
The line will be trimmed when it is connected to the engine.
Step 6
Slide the tie wrap through the fuel tank floor as shown.
Step 7
Insert the fuel tank in the fuselage. Make sure the vent line
faces the top of the fuselage. Guide the fuel line through the
hole in the firewall.
