7
Hangar 9 Pulse 125 ARF Assembly Manual
Step 7
Gently pull on the rudder and fin to make sure the hinges are
secure. If any of the hinges break loose, reapply CA to the
hinge.
Step 8
The last step is to break in the hinges. Move the rudder
through its range of movement a few times until it moves
freely.
Tail installation
Required Parts
Fuselage
Rudder/fin assembly
Elevator/stabilizer assembly 3mm washer (2)
3mm locknut (2)
Tools and Adhesives
Nut driver: 5.5mm
Thin CA
important
: Check and break in the elevator hinges
before starting this section of the manual. Apply thin CA
to any loose hinges.
Step 1
Position the stabilizer on the stabilizer saddle at the rear of
the fuselage.
Step 2
Insert the threaded rods from the fin through the holes in the
stabilizer and into the holes in the fuselage. You will need to
deflect the rudder so the control horn can pass the elevator.
Step 3
When installed, the fin will fit tight against the stabilizer.
