Feed Dog Height
(3 of 3)
9.
Now, insert it into the empty-threaded
4mm hole. Turn it clockwise with a 2mm
tool to raise and counter-clockwise to
lower the front-section of the feed dogs.
10.
Tighten the counter-threaded
Phillips locking washer screw deep
within the access hole; then replace the
4mm set screw back into the black
collar and retighten with a 2mm tool.
11.
Recheck the height using the feed
dog height gauge at the front of the feed
dogs. Set the gauge with side A facing
up. Rotate the hand wheel toward you.
If the feed dogs are too low, they will
not grab and move the gauge.
12.
Now flip the gauge so side B is
facing up and rotate the hand wheel
toward you.
If the feed dogs are too
high, they will grab and move the
gauge. Repeat the process if
necessary.
This is a counter-threaded set screw.
Turn it counter-clockwise to tighten.
31
