Hammond A-3, Playing Manual

Page: 136 / 180

HA<O> XK-5 Owner’s Playing Guide
136
❿ EXTERNAL ZONES - CONTROL CHANGE
Turns transmission of Volume and Pan parameters for each Exter-
nal Zone “ON” and “OFF.”
Other parameters such as Note, Expression and Damper are set
using the ZONES FUNCTION Mode.
u
KEYBOARD CHANNEL
This allows you to select the MIDI channel for each Keyboard
Channel. The setting range is 1 through 16 and OF. At OF, there
is no transmission.
⓫
TX UPPER
This allows you to select the MIDI Channel on which the UPPER
Keyboard Channel will transmit.
NOTE: The UPPER Keyboard Channel will transmit Note data,
Controller data, and Leslie data.
⓬ TX LOWER
This allows you to select the MIDI Channel on which the LOWER
Keyboard Channel will transmit.
⓭
TX PEDAL
This allows you to select the MIDI Channel on which the PEDAL
Keyboard Channel will transmit.
⓮ RX UPPER
This allows you to select the MIDI Channel on which the UPPER
Keyboard Channel will receive.
NOTE: The UPPER Keyboard Channel will receive Note data, Con-
troller data, and Leslie data.
⓯ RX LOWER
This allows you to select the MIDI Channel on which the LOWER
Keyboard Channel will transmit.
⓰
RX PEDAL
This allows you to select the MIDI Channel on which the PEDAL
Keyboard Channel will transmit.
⓱ TX MULTI CONTACT
⓲
RX MULTI CONTACT
These parameters allow you to select whether the Multi-Contacts
will transmit or receive MIDI data.
When “ON,” each contact will transmit on the MIDI channels
listed below regardless of the setting of the MIDI Channel patram-
eter.
Physical Contact MIDI Channel
UPPER, First 1
UPPER, Second 2
UPPER, Third 3
LOWER, First 4
LOWER, Second 5
LOWER, Third 6
PEDAL, First 7
NOTE: To avoid confusion of MIDI signals, set each MIDI Channel
for Keyboard Channels and External Zones to different num-
bers from the ones listed above.
u
SYSTEM EXCLUSIVE MESSAGE
⓳ DEVICE ID
This allows you to set the Device ID when transmitting System
Exclusive (Sysx) messages such as Memory Dump (#21, 22).
Hammond’s ID number is 55h.)
❿ RECEIVE DUMP
This allows you to turn reception of Memory Dump “ON” or
“OFF.”
On the XK-5, the total onboard memory can be transmitted as a
Memory Dump, as Sysx messages. To prevent reception of Mem-
ory Dump data, turn this parameter “OFF.”
⓫
TEMPORARY DUMP
This allows you to send a Memory Dump.
Pressing the [ENTER] Touch Button will transmit Patch Param-
eters, Global Parameters, System Parameters and the current set-
ting of the controls. The contents of each Patch as well as Leslie
Cabinets are not transmitted in this mode.
IMPORTANT: Recording a Temporary dump before you record a
performance to an external sequencer avoids setting mismatch-
ing when the sequence is played back.
⓬
ALL DUMP
This allows you to send a Full Memory Dump.
Pressing the [ENTER] Touch Button in this mode, transmits all
the settings through the MIDI OUT and USB TO HOST jack.
NOTE: Memory Dump data is transmitted through both the MIDI
OUT and USB TO HOST ports.
NOTE: None of these settings are Patche Parameters. They are
recorded upon setting, and are common at all Patches.