7-7
SECTION 7 –
DETASSELING SYSTEMS
•
To lower the cutting or pulling height
,
press the desired Depth Command
Switch(es) in the DOWN position.
•
To raise the cutting or pulling height
,
press the desired Depth Command
Switch(es) in the UP position.
DETASSELING SYSTEM -
OPERATION
Operating Instructions
1. Program the Tasseltrol®/LS System
12™ Control Panel.
NOTE: Refer to the manufacturer’s
operation manual for programming
instructions.
2. Test the Photo Light Sensors.
Auto Mode:
• Cover top photo lens and lift should move UP.
• Do not cover any of the lenses and lift should
move DOWN.
• Cover bottom photo lens and lift should stay in
position.
Manual Mode (Machine Off):
• When red LED is uncovered, LED should be ON.
• When red LED is covered, LED should be OFF.
NOTICE
Do not operate more than two (2) depth
command actuators at one time. Failure
to comply may result in blowing the
depth command fuse.
Depth Command Switches
(Located near the front of operator’s station)
-Typical View
Depth Command Actuator
(Located on the tool bar lift head tube)
-Typical View
Tasseltrol/LS System 12 Control Panel
(Located on the side console
- lift cover to access)
-Typical View
Summary of Contents for 204SP
Page 2: ...5 DASH AUTO...
Page 127: ......