Hagie 204SP, Operator'S Manual, Page: 62 / 127

SECTION 7 –
DETASSELING SYSTEMS
7-4
LS Photo Light Sensors
The LS Photo Light Sensors detect crop
height and send a signal to the LS System/
Depth Command, which controls automatic
height adjustment.
The upper and lower LS Photo Lights are
equipped with LED lights (A, C, D, E), which
indicate operation status.
•
The LT/DK (Light/Dark) Switch (A)
changes the activated condition of the
green LED from ON (LT) to OFF (DK).
• The Sensitivity Adjustment Screw (B)
should always be set to MAXIMUM.
• The Yellow LED Light (C) indicates that
power is ON.
• The Green LED Light (D) indicates out-
put energized (sending a signal to the
Tasseltrol Control Panel).
• The Red LED Light (E) indicates that the
photo light is receiving reflected signal.
Tasseltrol/LS System 12
Control Panel
The Tasseltrol/LS System 12 Control
Panel is used for programming the
detasseling heads. The control panel can
also be used to manually control the
detasseling heads.
Refer to the Tasseltrol manufacturer’s
operation manual for complete operating
instructions and information on programming
parameters.
Master Detasseler Switch
The detasseling head motors are
controlled by the Master Detasseler Switch
(located on the side console).
Quad Pullers
-Typical View
LS Photo Lights (Upper/Lower)
-Typical View
-Typical View
Tasseltrol/LS System 12 Control Panel
(Located on the side console
- lift cover to access)
-Typical View