SECTION 9 –
MISCELLANEOUS
9-23
Machine Valve Type
•
o
= Any machine with the original valve
(Model Year 2007 or prior).
•
p
= 204/204SP machines with the new
proportionate valve (Model Year 2008 or
later).
•
c
= STS Combo Sprayer/Detasseler with
the proportionate valve (Model Year
2007 or later).
•
x
= 204XP and DTS 8C (Combination
Sprayer/Detasseler) with 12 valves
(Model Year 2010).
To obtain further information on the status
of the Tasseltrol/LS System before
operation:
•
Turn the ignition key to the ON position
(do not start the engine).
•
Press the On/Off Switch (located on the
Tasseltrol Control Panel) in the UP (On)
position.
•
Press the Auto/Manual Switch (located
on the Tasseltrol Control Panel) in the
DOWN (Manual) position.
•
Ensure there is nothing physically block-
ing any upper or lower sensor’s path to
its reflector.
The display will show the status of the
upper and lower photo sensor on each lift
assembly. If the display shows a box (“ ”) in
all upper and lower areas, the unit is ready
for operation. If the display shows a corn
stalk (“ ”) in one or more areas, refer to the
following troubleshooting information.
NOTE: Left-Center sensors are used as
examples.
NOTICE
Ensure the machine valve type is
correctly selected to match the machine
in which the Tasseltrol® control box is
installed on.
Photo
Sensor Light
Status
Possible Cause
Lights at both
photo sensors
• Photo sensors not in line
with reflector. Contact your
local John Deere dealer for
assistance.
No lights at
either photo
sensor
• Faulty connector cable
(refer to your Parts Manual)
• Faulty wire in connector
cable (refer to your Parts
Manual)
Tasseltrol Display
Manual
Mode
Auto
Mode
Unit rises automatically
Tasseltrol Display
Manual
Mode
Auto
Mode
Unit does NOT rise automatically
Summary of Contents for 204SP
Page 2: ...5 DASH AUTO...
Page 127: ......