Hagie 204SP, Operator'S Manual, Page: 64 / 127

SECTION 7 –
DETASSELING SYSTEMS
7-6
All Up/Down Switches
The All Up/Down Switches (located on the
Hydrostatic Drive Control Handle) are used
to raise or lower all row units at the same
time.
•
Press and hold the RED All Up Switch to
move all row units UP simultaneously.
• Press and hold the GREEN All Down
Switch to move all row units DOWN
simultaneously.
“Up” parameters may be set to 0, 5, 10,
15, 20, or 25 seconds on the Tasseltrol
Control Panel. The detasseling heads will
move up this amount of time without having
to hold the red All Up Switch in (only in values
greater then 0). All detasseling heads will
hold this position when the pre-set parameter
is reached.
NOTE: To resume automatic depth control,
activate the green All Down Switch.
Refer to the Tasseltrol manufacturer’s
operation manual for information on
programming parameters.
Depth Command Switches
-If Equipped
The Depth Command Switches (located
near the front of operator’s station) allow the
operator to adjust the LS System cutting or
pulling height from the operator’s seat.
All Up/Down Switches
(Located on the Hydrostatic
Drive Control Handle)
-Typical View
• All Up
• All Down
Tasseltrol Control Panel
(Located on the side console
- lift panel to access)
-Typical View