Hagie 204SP, Operator'S Manual, Page: 116 / 127

SECTION 9 –
MISCELLANEOUS
9-15
5. Loosen Rear Lock Nut (located on leg
brace) to allow one leg to move further
than the other without binding (when
adjusting tread setting).
6. Lubricate the slide path in which the leg
mount will travel along mainframe
(approximately 30”/76 cm).
NOTE: Refer to “Service - Lubrication”
provided in the Maintenance and
Storage Section elsewhere in this
manual for further information.
7. Place a suitable prop item (e.g. wood
block) beneath the air bag mounting
plate (before raising the machine) to pre-
vent the suspension from telescoping, as
shown in the following illustration.
8. Raise the machine until the tires (on the
side being adjusted) are just touching
the ground.
To Adjust Tread Width Out
• Place a suitable prying tool beneath the
center of tire and pry out at the same
time, while simultaneously pushing out
at the top of the leg, as shown in the fol-
lowing photo.
Leg Mounting Bolts
(Six on each leg)
-Typical View
Rear Lock Nut
(Located on leg brace)
-Typical View
NOTICE
Failure to inspect and lubricate the tread
adjust bearing slide path may cause one
of the legs to “hang up” while the other is
still sliding during adjustment. Failure to
comply may result in machine damage.
-Typical View