3-14
Installation procedure
Follow these steps to complete magnet mounting:
Step1
As shown in Figure 3-22, use a Phillips screwdriver to pass the countersunk head screw through the
round hole at the center of the permanent magnet, fasten it to a blind nut in the dent of the device
bottom, and ensure that the permanent magnet and the device are fastened reliably.
Remove the cushion, if any, from the dent before installation.
Step2
Attach the magnet-mounted device to the specified location. Do not to get your fingers stuck between
because the magnetism is very huge.
Figure 3-22
Magnet mounting
(1)
(2)
(3)
(1) M3*6 countersunk head screw
(2) Permanent magnet
(3) Blind nut in the dent of the device bottom
