1-6
z
As a power sourcing equipment (PSE), the WX3000 series supports the IEEE 802.3af standard
while being compatible with some PoE powered devices that do not comply with the 802.3af
standard.
z
The WX3000 series provides power supply through fixed electrical Ethernet ports, with the
maximum power transmission distance of 100 meters (328.08 ft.).
z
Each Ethernet port of the WX3000 series provides a maximum of 25 W output power to the
attached PoE powered device. In the case of AC input, the maximum output power with full load of
the WX3024 is 370 W, and that of the WX3010 and WX3008 is 125 W; in the case of RPS input, the
maximum output power of the WX3024 is 25 W × 24 = 600 W (Note that the RPS output power
should be at least 700 W).
Components
LEDs
Table 1-6 lists the support of the WX3000 series for LEDs.
Table 1-6
LEDs supported by the WX3000 series
LED
WX3024
WX3010
WX3008
Power status LED (PWR)
Supported Supported
Supported
PoE/PoE+ status LED (Mode) Supported
Supported Supported
RPS status LED (RPS)
Supported
Not supported
Not supported
Gigabit Ethernet port status LEDs Supported Supported
Supported
Gigabit SFP port status LEDs
Supported
Supported
Not supported
Extension slot status LEDs (MOD1
and MOD2)
Supported
Not supported
Not supported
Table 1-7 shows the description of the LEDs status
Table 1-7
Description of the LEDs status
LED
Mark
Status
Description
Solid green
The system is going through the power on
self test (POST) or downloading software.
Blinking green (1 Hz)
The system is working normally.
Solid red
The system failed to pass the POST or has
detected a serious fault.
Solid yellow (1 Hz)
At least one port has failed the POST or
detected a minor fault.
Power status
LED
(green/yellow/red
)
PWR
Off
No AC input is present.
