3-22
Step3
After powering on the device, check the LEDs of the SFP interfaces. For details about the SFP LEDs,
refer to Table 1-7.
Installing and Removing Optional Interface Modules
z
The WX3010 and WX3008 do not support installing interface modules.
z
The interface modules and inner optical modules of the WX3024 are not hot swappable.
XFP Interface Modules
Introduction
10-Gigabit small form-factor pluggable (XFP) modules are used for electrical-to-optical and
optical-to-electrical conversion in optical signal transmission. An XFP transceiver requires fiber cables
with LC connectors.
Front panel of an XFP interface module
Figure 3-32
Front panel of an XFP interface module
Installing an XFP interface module
Step1
Put on an ESD-preventive wrist strap and verify that the wrist strap is properly grounded. Then, take the
XFP interface module out of the package.
Step2
Loosen the captive screws on blank panel covering an extension slot on the rear panel of the device
and remove the blank panel.
Step3
Take the XFP interface module by the captive screws on the front panel, and push the XFP interface
module steadily into the slot along the slide rails until it is firmly seated in the device.
Figure 3-33
Install an XFP interface module
