REMOTE CONTROL
107
This virtual port can perform the same functions as RS232 and use
the same settings as the RS232 port. It supports USB2.0 and below
version.
The USB device port on the rear panel is used for remote control.
The USB port is configured as CDC interface.
When configured to CDC, the USB port on the GBM-3000 series
will appear as a virtual COM port to a connected PC. Any terminal
program that can communicate via a serial port can be used for
remote control. Before the GBM-3000 series can be used for remote
control using the CDC USB class, install the appropriate CDC USB
driver included on the User Manual CD.
Configure USB Interface
Background
The Type B USB port on the rear panel is used for
remote control. This interface creates a virtual
COM port when connected to a PC.
Note
The USB interface requires the USB driver to be
installed. See page 108 to install the USB driver.
USB
Configuration
PC connector
Type A, host
GBM-3000 series
connector
Rear panel Type B, slave
Speed
1.1/2.0 (full speed/high
speed)
USB Class
CDC (Communications
device class)
Hardware flow control
Off
Data Bits
8
Stop bit
1
Summary of Contents for GBM-3080
