Reverse osmosis system
AVRO 125 TS/TL
Order no. 185 752 945-inter Edited by: nkes-mrie G:\BA-752945-INTER_185_AVRO_125.DOCX
18
5 | Scope of supply
5.1 Standard equipment
Stand-alone housing made of opaque PE to accommodate all
aggregates and control elements. Stand-alone housing also serves
as supply tank (AVRO 125 TS/TL-TS only).
Microprocessor controller with LC display, voltage-free collective
fault signal and voltage-free signal contact (maintenance interval,
various pre-warnings), installed in a stand-alone housing.
Sliding-vane rotary pump made of corrosion-resistant brass with
motor as high-pressure pump to supply the membrane, incl. control
valve for operating pressure and pressure gauge.
1)
External pressure booster with pressure switch and membrane
connection vessel for supplying permeate to downstream
consumers.
Hydro module for the water supply within the membrane system.
Integrated valves and measuring instruments for easier system
calibration.
5 µm drinking water filter with integrated pressure reducer, preset
to 2.5 bar.
Ultra-low pressure reverse osmosis membrane, installed in
pressure pipe made of high-strength PE.
AVRO treatment unit, installed in a pressure pipe made of high-
strength PE.
Flow sensor to measure the volume of the system flows permeate
and concentrate.
Operation manual.
1)
only AVRO 125 TS.
5.2 Optional features
Note:
It is possible to retrofit existing systems with optional
components. Please contact your local Grünbeck representative or
Grünbeck’s headquarters in Hoechstaedt for more information.
Connection
block
for
RO 125 K/AVRO 125
Connection block (installation length 180 mm).
Permeate-resistant incl. two shut-off valves –
suitable for connection set
752 840
Connection set for RO 125 K/AVRO 125
2 flexible connection hoses DN 15
(L = 600 mm) for feed water and permeate
1 drain hose for concentrate
752 830
